Pullman Coach Table Lamps 7mm Scale, for LED lighting. 'Cost Friendly'
Please use the contact form for more information or to place an order.
A design of Pullman Dining Table Lamp for 7mm Scale, to accept a nano LED. The lamps are printed in our 'clearish' resin, with a suitable hole through for the LED. The Bases can be painted with Primer, then Acrylic or Enamel paint can be used to finish off. These are printed in 50 micron layers (2 Thou). Finer layers can be printed but increase the cost of each part. If you would like to order, please use the contact form for more information.
LAMPS & Lights for 7mm Scale Models. Please use the contact form to make a request.
New design of 3D printed Loco and Brakevan Lamps, slot onto the RTR Lamp Holders. Easy change from front to rear of Loco. Easily Coloured etc.
Station Lamps, for Len Jones. These can be fitted with LED's and Brass tube to make them into fully working models.
See Pictures below, thank you to Len for the information.
These Lamps can be fitted with LED's but you have to replace the Curved Top with a brass metal tube. I suggest using a piece of flexible Florists wire to push down the brass tube before forming to the profile of the 3D Printed lamp top shape, Pattern provided.
This is to Stop the brass tube kinking or crimping as you work the shape.
More lamp designs will be added here as time passes.
This is to Stop the brass tube kinking or crimping as you work the shape.
More lamp designs will be added here as time passes.